A: Yes "Bob 3" ... It is a direct replacement as I installed one in my B-198 u-Line. With the u-line setting on a bench at eye level, you can do it in about 45 to 60 minutes. A little harder if the unit is setting on the floor. Answer provided by:  Gerald (5/8/2015)

A: Bob H. I installed this unit last year and has been working great making ice continually, I would say that this is a good unit and works great... Answer provided by:  Larry (9/24/2015)

A: I'm 400 miles from the refrigerator into which I installed my new Ice Maker Assembly. Thus, I cannot tell you what the precise model # of unit is. However, I can tell you that you unit was manufactured in 1986. Thus, if your unit was manufactured from 1986 on, I'm reasonably confident it will work OK. Answer provided by:  Alexander (9/24/2015)

A: The 402 ice maker fits most U-Line with minimal worries. The electric plug that comes with the new ice maker will need to be cut and the new unit but-spliced (crimp connects) to the original unit. Remember to cut old and new wires as long a possible to alloy for the new wire connects. If you're not familiar with wire connects or feel uncomfortable dealing with electrical repair, please consult an appliance repair tech. ,Ralph Answer provided by:  Ralph (5/6/2015)

A: Some models have disconnects and other do not. If you need too, clip off the connector and wire color to color. If there is a fifth wire clip off the tail and ignor it. Answer provided by:  Robert (11/1/2014)

A: Chris, It has an Thermal adhesive on it to keep it to the cooling metal around it, you just pry it off and clean up the old adhesive and put on new, which you should have recieved with the unit... HTH Answer provided by:  Larry (7/5/2015)

A: It worked in mine with no problems. Answer provided by:  Dennis (5/8/2015)

A: Yes it was accurate. Had no problem installing it. The bare wires connected directly to a terminal strip on the old unit. Can't answer your question about differences. If I were to guess the unit with no connector would more readily attach to different units. If the connector doesn't fit your unit then you would have to cut it off and wire direct anyway. Hope this helps. Answer provided by:  Bobby (10/27/2014)

A: The one I purchased had the connectors. I don't know if it changed. Answer provided by:  Kay A (10/27/2014)

A: you have to feed the wires thru a small hole to the backside Answer provided by:  jesse (10/27/2014)

A: Your refrigerator requires part # 80-39010-00. Currently we do not carry this item but working with a supplier to obtain this product Answer provided by:  Janice (6/10/2013)

A: We would need the model number of the refrigerator to check that for you. We are not sure what you meant by cm 45 a. Answer provided by:  Janice (3/12/2013)

A: Yes this is an OEM original part manufactured by WHirlpool Answer provided by:  Janice (9/8/2015)

A: factory recommended Answer provided by:  Dennis (5/15/2015)

A: good price Answer provided by:  Mark (5/14/2013)

A: It was the part I needed. Answer provided by:  DG (3/25/2013)

A: replacement for non working one Answer provided by:  Michael (3/7/2013)

A: Found the item I needed and you had it ready to ship! Answer provided by:  Brad (1/28/2013)

A: mine stop working after 4 years Answer provided by:  jesse (1/27/2013)

A: old assembly was broken Answer provided by:  maurice (1/12/2013)