Merlin Reverse Osmosis (RO) Drinking Water System is a water treatment unit. It uses water pressure to reverse a natural physical process called osmosis. Water, under pressure, is forced through a semipermeable membrane to filter out minerals and impurities. Treated drinking water goes to the faucet. Minerals and impurities are sent to the drain with RO waste water.
The system includes replaceable filters and membrane elements. The prefilter reduces sand, silt, dirt, rust particles, other sediments, and chlorine from the water supply before they enter the RO membrane elements. The postfilter reduces any tastes and/or odors that may remain in the water after passing through the RO membrane elements.
Includes complete kit - faucet, cold water line connection tee, drain connection first set of filters and membranes. Like no other system!
- Continuous flow – no storage tank necessary
- Uses line pressure only (>40 psi/2.76 bar)
- 1/2 gpm (1.89 lpm) permeate rate @50 psi (3.44 bar) + 77°F (25°C)
- Requires no pump, no electricity (>40 psi/2.76 bar)
- Compact design – fits easily under sink
- Water Quality Association Gold Seal – NSF/ANSI 58 Certified
- Consistent membrane efficiency
- Complete product literature and training support
- Consistent high recovery system means less water going to drain
- Multiple dispensing locations off one system*At 50 psi (3.44 bar), 77°F (25°C), 750 ppm NaCl
Tubing/Fitting Dimensions
- Inlet Tubing 4 feet of 1/2" natural tubing (1.22 meters of 12.7 mm natural tubing)
- Concentrate Tubing 4 feet of 3/8" black tubing (1.22 meters of 9.53 mm black tubing)
- Permeate Tubing 4 feet of 3/8" blue tubing (1.22 meters of 9.53 mm blue tubing)
- Drain Tubing 3 feet of 1/2" red tubing (for airgap installation) (0.91 meters of 12.7 mm red tubing)
- Drain Connection 3/8" or 1/2" (9.53 mm or 12.7 mm)
- Carbon Post Filter 3/8" quick disconnect fittings (9.53 mm quick disconnect fittings)
